(1) Prepare your cable according to manufacturers
specifications, wipe clean and prepare for connection, as earlier outlined
in the Cable and Connector Preparation.
(2) Remove the two-piece sleeves from the
pouch, intact. Slide both sleeves as one unit over the prepared
cable end, and position the sleeves down the cable to allow enough room
(3) Install connector into housing and onto
the cable. Complete connection.
(5) With a slight twisting and pushing motion,
slide the outer sleeve up and over the connector, butting the end of the
outer sleeve against the housing. Properly installed, a small portion of
the inner sleeve (A) is visible at the other end of the outer sleeve. The
installation is complete.